KyroCLEAN: KyroCLEAN -Highly efficient cleaner for drinking water tanks

KyroCLEAN^®

is the partner from Kyrol TC

Highly efficient cleaning agent for drinking water tanks

- approved according to DVGW (German Technical and Scientific Association for Gas and Water) W 319 –

No lumping. Flows freely. Doesn't dust. Dissolves quickly. Powder and solution: odourless.

Gentle on materials: does not attack cement, mortar or concrete surfaces.

Neither alkaline nor acidic

KyroCLEAN^® is a dithionite based cleaning agent. It is used to clean drinking water containers, tanks, reservoirs and fountains. It can be used on any surface.

KyroCLEAN^® effectively removes iron, manganese and other sediments as well as biological deposits and algae.

KyroCLEAN^® dissolves quickly in water. The odourless cleaning solution is easy to use. The sprayed cleaning solution does not flow too quickly from surfaces due to its viscosity. Thus it can act on the deposits and leave clean surfaces for later disinfection.

Properties of the KyroCLEAN^® powder:

· no lumping

· flows freely

· odourless

· dissolves completely

· not dangerous according to transport regulations

Properties of the KyroCLEAN^® cleaning solution:

· can be used on any surface

· no unpleasant odours

gentle on materials: does not attack cement, mortar or concrete surfaces
neither alkaline nor acidic
can be easily applied on the surface to be cleaned with low pressure spray
excellent cleaning power, more effective than conventional cleaners for drinking water tanks

also removes algae and other organic deposits
can be easily washed off with a water jetcorresponds to the minimization requirement

Instructions:

Dissolve the contents of the bottle of KyroCLEAN^® in 25 – 40 litres of water while stirring.

The cleaning solution can easily be applied to all surfaces to be cleaned with low pressure spray. Because of its viscosity the cleaning solution does not flow off surfaces quickly and thus dissolves deposits thoroughly. The treated surfaces can then be rinsed with a jet of water.

Instruction manual:

1. Wear protective clothing: helmet, face protection, rubber gloves.

2. Drain drinking water tank / reservoir.

3. Use a jet of water to flush out any loose deposits and sediments in the tank.

4. Fill the mixing container with 25 – 40 litres of tap water.

5. Add 1 kg of KyroCLEAN^® powder and dissolve while stirring gently.

6. Apply the KyroCLEAN^® solution with a low pressure spray.

7. The KyroCLEAN^® solution is sprayed at a working pressure of approx. 1 bar at the nozzle. Apply from top to bottom without misting.

8. Do not exceed a maximum surface reaction time of 30 minutes.

The KyroCLEAN^® solution should be processed within 5 hours. It is not possible to store the KyroCLEAN^® solution. Attention! Do not apply any other chemical on surfaces being treated with KyroCLEAN^®.

9. It is possible to drain the spray water into the sewage system, as long as local regulations are observed. A sulphite limit of less than 40 mg/l must be observed when draining into the discharge system. If necessary, dilute the spray water before draining.

10. Immediately refill the tank with drinking water and sample it